Contura C 556 Installation Instruction
Hide thumbs
Also See for C 556:
- Installation instructions manual (12 pages) ,
- Installation instructions manual (14 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Contura C 556
Summary of Contents for Contura C 556
- Page 1 Installation instruction C 556 www.contura.eu...
- Page 2 See rating plate on the stove Intended area of use Heating of rooms in residential buildings Fuel Wood MANUFACTURER Name NIBE AB / Contura Address Box 134, Skulptörvägen 10 SE-285 23 Markaryd, Sweden CHECKS According to AVCP System 3 European standard...
-
Page 3: Table Of Contents
A warm welcome to the Contura family. We hope you will get a great deal of pleasure from your new stove. As a new owner of a Contura stove, you have secured a product with timeless design and long service life. -
Page 4: Technical Details
FACTS Important to remember! Technical details Installation by authorised Structural support Effect 3-7kW Nominal effect 5 kW technician Check that the wood joists are strong Efficiency up to 79% enough to bear the weight of the stove and This manual contains instructions about chimney. - Page 5 REMOVAL How to remove the heat deflector How to remove the hearth surround (Vermiculite) Handle the vermiculite with care. Lift the smoke baffle with one hand whilst removing the sides pieces. Reinstall in reverse order...
-
Page 6: Connection To Chimney
CHIMNEY Connection to chimney • A flue with sharp bends and horizontal routing reduces the • The stove meets the requirements for connecting to chimneys dimensioned for 350°C flue gas temperature. draught in the chimney. The maximum horizontal flue is 1 m, on the condition that the vertical flue length is at least 5 m. -
Page 7: Supply Of Combustion Air
1 m the pipe diameter must be increased to 100 mm and a correspondingly larger wall vent must be selected. C 556 In hot areas the duct should be insulated with 30 mm mineral wool covered with a moisture inhibitor (plastic). It is important that the... -
Page 8: Installation Distances
INSTALLATION DISTANCES Installation distances C 556 The minimum distance in front of WHEN INSTALLING TURNTABLE (OPTION) the the stove opening to combustible following installation distances do not apply. parts of the building or interior See the separate turntable installation instruc- Combustible roof decoration must be at least 1 m. -
Page 9: Assembly
ASSEMBLY Installing C 556 Wait to tighten the back panel’s upper screws until Clean the side glass the side panels are installed. thoroughly before installing the side panels. Installing rating plates The following rating plates must be placed on the underneath of the heat deflector. The heat deflector can be removed and is not used with the fan option. - Page 10 ASSEMBLY READY! If the stove’s loose components are removed these must be reinstalled in reverse order when the stove is put in place. Final inspection of the installation It is extremely important that the installation is inspected by an authorised chimney sweep before the stove is used.
- Page 12 NIBE AB · Box 134 · SE-285 23 Markaryd · Sweden www.contura.eu Contura reserves the right to change colours, materials, dimensions and models at any time without special notice. 811116 IAV SE-EX C556 - 4 Your dealer can give you the most up to date information.