Positioning The Base-Plate; Making A Hole Through The Ceiling; Installing The C-460 Wall-Protection Panel - Contura C 460 Installation Instruction

GB
7

Positioning the base-plate

The metal template indicates the position of the stove body, the
concrete surround and the hole in the ceiling for the flue. The
rear edge of the surround will later be aligned exactly with the
rear edge of the template.
Place the base-plate on the floor – after first ensuring that
you have observed all the requisite safety distances (see page
3) – so that the hole in the plate that marks the centre of the
chimney is at the required distance from the wall. If a wall
protection panel is to be installed, the template is fitted against
the panel.
Screw the base-plate to the floor.
c:a 50

Making a hole through the ceiling

380
When drawing a flue from the top of the stove to a steel
chimney, you need to make a hole through the ceiling. Ensure
that the centre of the hole is directly above the mark on the
base-plate (the floor template) that indicates the centre of
the chimney. For chimney installation, please refer to the
installation instructions supplied with the chimney.
At this stage fit only the rear section of the ceiling insulation. It
is important that the ceiling insulation plate is centred over the
hole in the ceiling.
44
380
Installing the C-460 wall protection panel
Screw the outer steel profiles to the wall 1200 mm apart.
Ensure that they are absolutely perpendicular. Place the air
holes by the floor and ceiling. The two profiles are 2500 mm
long. If the ceiling is lower, use a hacksaw or metal shears to cut
the profiles to the appropriate height. To make this easier, there
is a die-cut slot 100 mm from the end (see illustration). Place
the two remaining profiles between the outer ones.
Cut the minerit boards to the desired width. Position the minerit
boards edge to edge with a bead of acrylic sealant in the gap
and screw them into place with the supplied screws. Do not
install the upper board until the rear section of the headlining
seal has been installed.
Die-cut slot
Utstansning