Contura C 460 Installation Instruction page 14

GB
12
File off any uneven edges on the inside of the door. Screw the
mounting plate for the hinge into place in the pre-drilled holes
in the door, and then fit the hinge to the mounting plate.
Drill as marked with a 5 mm drill. Press screw plugs into the
holes and screw the hinges into place.
Adjust the hatch to an exact fit by turning the adjust ing screws
on the hinges. Turn the screw as indicated by the arrows
stamped into the metal.
Place the plinth on the base-plate. The rear edge of the plinth
must be flush with the rear edge of the base-plate.
Simply stand the filler-piece for the plint h loose in place, or
squeeze out a few small blobs of acrylic sealant to keep it from
moving. Note, however, that it must be possible to remove the
filler-piece when cleaning the stove or servicing the fan.
Place the hatch in the gap in the plinth and make drilling marks.
!
If a fan is to be connected, make holes for the
cables either in the wall or in the back of the plinth.
Draw the cables through the hole before securing
the plinth to the base-plate.