Advertisement
Advertisement
Related Manuals for Contura C 620S
Summary of Contents for Contura C 620S
- Page 1 Installation instruction C 620S C 620T C 660T www.contura.eu...
- Page 2 CERTIFICATE PERFORMANCE DECLARATION No. C620-C660 CPR-130608-SE-1 PRODUCT Product type Stove lit with solid biofuels Type designation Contura 620S, 620T, 660T Manufacturing number See rating plate on the stove Intended area of use Heating of rooms in residential buildings Fuel Wood...
-
Page 3: Table Of Contents
A warm welcome to the Contura family. We hope you will get a great deal of pleasure from your new stove. As a new owner of a Contura stove, you have secured a product with timeless design and long service life. -
Page 4: Technical Details
FACTS Important to remember! Technical details Installation by authorised Structural support Effect 3-9 kW Nominal effect 6 kW technician Check that the wood joists are strong Efficiency up to 80% enough to bear the weight of the stove and This manual contains instructions about chimney. - Page 5 REMOVAL How to remove the hearth surround (Vermiculite) Handle the vermiculite with care. Lift the smoke baffle with one hand whilst removing the sides pieces. If necessary, move the cast-iron firebed slightly. Reinstall in reverse order The heat reflecting plate must be fitted underneath the body of the stove if the area below is to be used as a log-box.
-
Page 6: Connection To Chimney
CHIMNEY Connection to chimney • A flue with sharp bends and horizontal routing reduces the • The stove meets the requirements for connecting to chimneys dimensioned for 350°C flue gas temperature. draught in the chimney. The maximum horizontal flue is 1 m, on the condition that the vertical flue length is at least 5 m. -
Page 7: Supply Of Combustion Air
SUPPLY AIR/ACCESSORY Supply of combustion air When a stove is installed in a room, the demand for air supply to the room increases. Air can be provided indirectly via a vent in the outer wall or via a duct from the outside that is connected to the connector on the underneath of the stove. -
Page 8: Installation Distances
INSTALLATION DISTANCES Installation distances C 620S/ 620T/ 660T The minimum distance in front of WHEN INSTALLING TURNTABLE (OPTION) the the stove opening to combustible following installation distances do not apply. parts of the building or interior See the separate turntable installation instruc- Combustible roof decoration must be at least 1 m. - Page 9 ASSEMBLY Installing C 620S, C 620T, C 660T...
- Page 10 ASSEMBLY C 620 Handle sandstone / soapstone with care, the edges are susceptible to C 620 damage.
- Page 11 ASSEMBLY Install the convection fascia, warming shelf or baking oven according to the instructions in the section for the relevant accessory on pages 76 to 77. This must be done before the top is installed. Installing rating plates The rating plate supplied is placed on the back, either internally or externally.
-
Page 12: Installation Of Oven (Option)
ASSEMBLY Installation of oven (option) Hold the oven door in place on the threaded pin. Hook the top hinge in place and loosely tighten one of the screws. Close the oven door and adjust it so that it aligns horizontally. Then open it carefully and tighten both screws. -
Page 13: Installation Of Warming Shelf (Option)
ASSEMBLY Installation of warming shelf (option) Place the bottom plate for the warming shelf in the heating compartment, use the adjuster screw at the rear edge for level horizontal installation. Only 660T Place paper from the packaging as scratch protection because the upper section must be slid into position. - Page 14 ASSEMBLY Installation of drawer (option) When installing the drawer, the knockout in the back panel must always be removed for the supply of convection air. Slacken off the rear Allen screws three turns. Place the pull-out unit on the base plate. Hook the pull-out unit into place over the rear Allen Install the drawer on the pull-out unit using the four screws.
- Page 16 NIBE AB · Box 134 · 285 23 Markaryd · Sweden www.contura.eu Contura reserves the right to change colours, materials, dimensions and models at any time without special notice. 811113 IAV SE-EX C620S/ 620T/ 660T - 4 Your dealer can give you the most up to date information.