Contura C 586 Installation Instruction
Hide thumbs
Also See for C 586:
- Installation instructions manual (12 pages) ,
- Installation instructions manual (14 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Contura C 586
Summary of Contents for Contura C 586
- Page 1 Installation instruction C 586 www.contura.eu...
- Page 2 See rating plate on the stove Intended area of use Heating of rooms in residential buildings Fuel Wood MANUFACTURER Name NIBE AB / Contura Address Box 134, Skulptörvägen 10 SE-285 23 Markaryd, Sweden CHECKS According to AVCP System 3 European standard...
-
Page 3: Table Of Contents
A warm welcome to the Contura family. We hope you will get a great deal of pleasure from your new stove. As a new owner of a Contura stove, you have secured a product with timeless design and long service life. -
Page 4: Technical Details
FACTS Important to remember! Technical details Installation by authorised Structural support Effect 3-7kW Nominal effect 5 kW technician Check that the wood joists are strong Efficiency up to 79% enough to bear the weight of the stove and This manual contains instructions about chimney. - Page 5 REMOVAL How to remove the hearth surround (Vermiculite) Handle the vermiculite with care. Lift the smoke baffle with one hand whilst removing the sides pieces. Reinstall in reverse order...
-
Page 6: Connection To Chimney
CHIMNEY Connection to chimney • A flue with sharp bends and horizontal routing reduces the • The stove meets the requirements for connecting to chimneys dimensioned for 350°C flue gas temperature. draught in the chimney. The maximum horizontal flue is 1 m, on the condition that the vertical flue length is at least 5 m. -
Page 7: Supply Of Combustion Air
In hot areas the duct should be insulated with 30 mm mineral wool C 586 covered with a moisture inhibitor (plastic). It is important that the There is a detachable cover on the reverse... -
Page 8: Installation Distances
INSTALLATION DISTANCES Installation distances C 586 C 586 Combustible roof WHEN INSTALLING TURNTABLE (OPTION) the The minimum distance in front of the stove opening to combustible following installation distances do not apply. See the separate installation instructions for parts of the building or interior turntable. -
Page 9: Assembly
ASSEMBLY Installing C 586 Do not tighten the screws until the stove has been raised again. Wait to tighten the back panel’s screws until the side panels are installed. Installing rating plates The following rating plates must be placed on the underneath of the pillar frame. - Page 10 ASSEMBLY Clean the side glass thoroughly before installing the side panels. Final inspection of the installation It is extremely important that the installation is inspected by an authorised chimney sweep before the stove is used. Also read the ”Lighting instructions”, before lighting for the first time.
- Page 12 NIBE AB · Box 134 · 285 23 Markaryd · Sweden www.contura.eu Contura reserves the right to change dimensions and procedures described in these instructions at any time without 811117 IAV SE-EX C586 -4 special notice. The current edition can be downloaded from 2014-04-09 www.contura.eu...