Parmco PPOV-6S-PYRO Installation And Operating Instructions Manual page 21

Fitting on a power supply cable
Opening and remove the terminal board cover. To install the cable, proceed as follows:
 Remove the wire clamp screw and the three contact screws L‐N ‐
 Fasten the wires beneath the screw heads using the following color
scheme: Blue (N) Brown (L) Yellow‐Green
 Secure the supply cable in place with the clamp and close the cover of
the terminal board.
Connecting the supply cable to the mains
Install a standardized plug corresponding to the load indicated on the data plate. When
connecting the cable directly to the mains, install an isolator. The isolator switch should be
rated according to the load and should comply with current regulations (the earth wire should
not be interrupted by the circuit breaker).
The supply cable should be positioned so that it does not reach a temperature of more than
50°C higher than the room temperature, anywhere along its length, or should be protected by
insulation sleeving with an appropriate temperature rating.
Before switching the appliance on, please note:
 The electrical safety of this appliance can only be guaranteed if the oven is correctly and
efficiently earthed, in compliance with local regulations on electrical safety. Always ensure
that the earthing is efficient; if you have any doubts call in a qualified electrician to check the
system. The manufacturer declines all responsibility for damage resulting from a system
which has not been earthed properly.
 Check that the specifications indicated on the data plate (on the appliance and /or packaging)
corresponds to those of the electrical mains system of the home.
 Check that the electrical capacity of the system and sockets will support the maximum
power of the appliance, as indicated on the data plate. If you have any doubts, call in a
qualified technician.
 If the socket and appliance plug are not compatible, have the socket replaced with a suitable
model by a qualified technician. Also ensure that the cross sections of the socket cables are
suitable for the power absorbed by the appliance. The use of adapters, multiple sockets and
/or extensions are not recommended. All electrical work must comply with local regulation.
The plug and socket must be easily accessible.
22