Overview; Specifications - AMX NMX-ENC-1100 Instruction Manual

Overview

The NMX-ENC H.264 encoder is an audio/video encoder which supports high-definition video and H.264 encoding from sources
including PCs, cameras, and set-top boxes. The encoder can stream either unicast and multicast streams.
The NMX-ENC is available in two different versions: NMX-ENC-1100 (FG3201-01) and NMX-ENC-1105 (FG3201-02). The
NMX-ENC-1105 has the same features as the NMX-ENC-1100 and adds SDI input and pass-thru ports on its rear panel.
NMX-ENC H.264 encoder
FIG. 1
Specif ications
The following table lists the specifications for the NMX-ENC H.264 encoder:
NMX-ENC H.264 Encoder Specif ications
Active Power Requirements
Power Connector:
Power Capabilities:
Front Panel Components
LEDs:
AUDIO IN:
USB:
ID:
Rear Panel Components
SDI:
MULTI FORMAT VIDEO INPUTS: 1 DVI connector for multi-format video inputs. See the MULTI FORMAT VIDEO INPUTS section on page 14
AUDIO:
VIDEO PASS THRU:
KEYPAD:
INDICATORS:
USB:
LAN 10/100:
Instruction Manual - NMX-ENC H.264 Encoder
1 2-pin 3.5mm locking Phoenix connector
• Maximum Current Draw: 13W
• Typical Current Draw: 10W
• Operating Voltage: 10VDC to 18VDC
All LEDs appear in green (active) or red (alarm state).
• STREAM - shows streaming status
• VIDEO IN - notes video input status
• POWER - notes power and alarm state
• USB - notes data copying state
See the LEDs section on page 11 for more information.
2 sets of AUDIO IN LEDs indicating the signal strength of the audio input with separate sets of indicators
for the left (L) and right (R) channels. See the AUDIO IN section on page 12 for more information.
1 Type-A USB connector. The port has an LED beside it which indicates the state of sending data to a
connected USB storage device. See the USB section on page 12 for more information.
1 ID pushbutton to assign a device address to the encoder or copy a configuration information file to a
connected USB drive. See the ID section on page 12 for more information.
These connectors are only available on the NMX-ENC-1105.
• 1 BNC connector for video input (INPUT)
• 1 BNC connector for video output (PASS THRU)
See the SDI section on page 13 for more information.
for more information.
• 1 3.5mm mini-phono connector for audio input (INPUT)
• 1 3.5mm mini-phono connector for audio output (PASS THRU)
See the AUDIO section on page 14 for more information.
1 HDMI connector for video output. See the VIDEO PASS THRU section on page 15 for more information.
1 3-pin 3.5mm Phoenix connector for RS-232 ports. See the KEYPAD section on page 15 for more
information.
1 4-pin 3.5mm relay port. The port features a 2-pin Recording port (Port 2) and a 2-pin Streaming port
(Port 1). See the INDICATORS section on page 16 for more information.
1 Type-A USB connector. See the USB section on page 16 for more information.
4 RJ-45 LAN ports for network connections via Cat5 cabling.
NOTE: You should ALWAYS connect your main network artery to the port 1 LAN port.
See the LAN 10/100 section on page 16 for more information.
Overview
8