AMX NMX-ENC-1100 Instruction Manual page 33

Recording Options (Cont.)
Enable Store and Forward
Enable NTP
Zone
Enable DST
Instruction Manual - NMX-ENC H.264 Encoder
Check this box to configure an FTP server to which the encoder will automatically upload a recorded file
when the recording is complete. Forwarding is only supported through the USB port on the rear panel of
the encoder. Video files of the USB port are deleted from the USB device once forwarding is successful.
NOTE: If you have a storage device connected to the rear USB port and you do not have Store and
Forward enabled, the drive will eventually f ill with data. When f illed, you must manually remove the
drive to clear its data. Store and Forward does not work without a USB drive connected to the
encoder as there is not internal memory dedicated to temporarily storing video before it is
forwarded to the FTP server.
When you check this box, the following options appear:
• Forwarding Schedule: Select from the menu a time window in which you want to transfer the recorded
contents to the FTP server. You can choose from Immediate, Specif ied Time, and Specif ied Start
Window. You must enable an NTP server before configuring either of the latter two choices. If you
choose Immediate, the FTP process starts as soon as a there is no active recording session in
progress. If you select the forwarding schedule for a specified time or start window, use the options
menus that appear to indicate recording times. If you select a time when a file transfer is In Progress,
the files are transferred at a random time within the forwarding window to decrease the potential for
network congestion or load on the FTP server.
• FTP URL: Enter the URL or IP address of the FTP server.
• FTP Port: Enter the port of the FTP server.
• Username: Enter the username for access to the FTP server.
• Password: Enter the password for access to the FTP server.
Check this box to enable the encoder to embed the time in the video stream and support time-based
store-and-record operations. Though you can have multiple predefined NTP servers, the encoder only
queries the selected NTP server for the current time. The encoder will not attempt to query the other
predefined NTP servers in the event the selected NTP server is not available.
NOTE: If NTP is enabled when the encoder reboots and an invalid date and time is set on the
encoder, the encoder will be in a Not Allowed state for streaming or recording. Waiting for the
encoder to retrieve a valid date and time or disabling NTP will allow the encoder to stream and
record again.
Use the menu to select the time zone.
Check this box to enable Daylight Savings Time (DST) on the encoder. Enabling DST opens a series of
additional options. You must select a Type, and you can choose from Fixed or By Occurrence. For each
option you can indicate the following parameters:
• Offset: Set the number of hours and minutes in the time adjustment.
• Starts: Set the time of day when the time adjustment should take effect.
• Ends: Set the time of day when the time adjustment should end.
• Month: Set the month of the year when the time adjustment should start and end.
• Day: Set the day of the week when the time adjustment should start and end. This option is only
available when you select Fixed.
• WoM: Set the week of the month when the time adjustment should start and end. This option is only
available when you select By Occurrence.
• DoW: Set the day of the week when the time adjustment should start and end. This option is only
available when you select By Occurrence.
Web Configuration
33