AMX NMX-ENC-1100 Instruction Manual page 10

Perform these steps to mount the encoder using the NMX-VRK Rack Shelf:
1. Invert the encoder and the rack shelf for ease of installation.
2. Attach the rack shelf to the bottom of the encoder using the #4-40 3/16 inch undercut flat head screws (provided). Insert the
screws through the underside of the rack shelf and into the holes on the bottom of the encoder. Note that only two screws are
required.
3. Install the rack shelf in a standard EIA 19 in. (48.26 cm) rack and secure with rack-mounting screws.
4. (This step is optional.) Attach fill plates using the #4-40 3/16 inch undercut flat head screws (provided). Be sure to use the
screw holes closest to the front of the tray.
5. Use wire ties (not provided) to mount the power supply to the rear section of the rack shelf. This step is optional.
Instruction Manual - NMX-ENC H.264 Encoder
Overview
10