Wiring And Device Connections; Overview; Front Panel Components; Leds - AMX NMX-ENC-1100 Instruction Manual

Wiring and Device Connections

Overview

This section describes the front and rear panel components for the NMX-ENC-1100 and NMX-ENC-1105. Wiring information for
port connectors is listed in each connector's corresponding section.

Front Panel Components

The following section lists the components on the front panel of the NMX-ENC encoder.
NMX-ENC (front panel)
FIG. 3

LEDs

All LEDs appear in green or red, and in solid or blinking states. Consult the LED States table on page 11 for more information.
STREAM - shows streaming status

VIDEO IN - notes video input status

POWER - notes power and alarm state

USB - notes record and file copying state, and the USB mounting status

NOTE: The LEDs can be dimmed by selecting an option in the WebConsole pages. See the
information.
FIG. 4 displays the LEDs on the front panel.
Front panel LEDs
FIG. 4
Consult the following table for the meaning of each LED indicator:
LED States
LED
STREAM
VIDEO IN
POWER
USB
NOTE: Failure to retrieve an IP address LED indication is only valid in a DHCP-conf igured network.
Instruction Manual - NMX-ENC H.264 Encoder
LEDs
OFF Green
Not streaming Streaming in
progress
No video input Valid video signal
signal detected
No power applied Power applied
Neither drive is Device is
present, or the successfully
inserted drive is connected and
not mounted or mounted. Attached
there is an issue drive can be
with the inserted removed without
drive. damaging its
contents.
Audio signal
strength indicators
Slow Blinking Fast Blinking
Green Green
N/A N/A
Unknown Signal. N/A
This signifies that
the selected format
does not match the
detected format.
System is booting N/A
N/A Writing
configuration file
to the front USB
port.
Wiring and Device Connections
USB ID
pushbutton
System section on page 35
Red Slow Blinking Red
N/A Streaming has
been suspended.
Unsupported An encrypted video
resolution signal is being
used as the video
input.
N/A Network failure or
failure to retrieve
IP address (see
note below)
Device is currently Error in record, or
recording. device is full.
for more
11