Turn Signals - Victory Motorcycles 2010 Victory Cross Roads Rider's Manual

9922671.book Page 82 Tuesday, June 16, 2009 12:06 PM
Pre-Ride Inspections
Turn the ignition key to the ON position and move the stop/run switch to RUN before per-
forming the following electrical inspections. Return the ignition key to the OFF position
after completing these inspections. If inspection of any electrical item reveals component
failure, repair or replace the component before operating the motorcycle.
Item
Headlamp Switch to high beam. Verify that the high beam indicator comes on and that
lamp brightness increases.
Taillight/Brakelight Verify that the taillight and license plate light illuminate. Verify that the taillight
lamps increase in brightness when the front brake lever is applied and also
when the rear brake pedal is applied.

Turn Signals

Move the turn signal switch to the left. Verify that front and rear left turn signals
flash, as well as the corresponding light on the indicator panel. Push the switch
inward to cancel the signal. Verify that the signals and the indicator light stop
flashing. Repeat the procedure for the right turn signals.
82
Inspection Procedure
Electrical