Victory Motorcycles 2010 Victory Cross Roads Rider's Manual page 105

9922671.book Page 101 Tuesday, June 16, 2009 12:06 PM
Sidestand
1. On level ground, straddle the motorcycle and bring it to the fully upright position.
2. Move the sidestand up to the stored position and down to the fully extended position sev-
eral times. It should move smoothly and quietly. Make sure the return spring holds the
sidestand tightly in place when the sidestand is in the stored position. Adjust or replace a
loose spring.
3. Inspect the sidestand pivot bolt for
looseness or wear. Tighten or replace
a loose or worn bolt.
4. Inspect the sidestand rubber pad.
Make sure the pad is firmly attached
to the sidestand. Check the wear
indicator on the leading edge of the
pad. Replace the pad when it's worn
beyond the wear limit line.
Pre-Ride Inspections
Wear Limit
Line
Pivot Bolt
Front of Motorcycle
101