Executing Calibration - Fuji Xerox Color 550 Administrator's Manual

Executing Calibration

The machine can automatically calibrate colors when the reproducibility of density or
color in copies and prints deteriorates. The available screen types are [Copy Job 1],
[Copy Job 2], [Print Job 1], and [Print Job 2].
We recommend executing auto calibration for all four screen types. When the
adjustment for one screen type is complete, specify the next screen type and repeat
the procedure.
Note
The following describes how to perform calibration.
1
Select [Calibration] on the [Services Home]
screen.
If [Calibration] is not displayed, follow the
procedure below.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID
with the numeric keypad or the keyboard
displayed on the screen, and select
[Enter].
When a passcode is required, select [Next]
and enter the system administrator's
passcode, and select [Enter].
Note
• If color is not calibrated despite the periodic execution of auto calibration, contact your local
Fuji Xerox representative.
• Confirm the settings of the following items under [Tools] > [System Settings] > [Copy Service
Settings] > [Copy Defaults] in the System Administration mode before executing auto
calibration:
- Lighten/Darken: Normal
- Contrast: Normal
- Sharpness: Normal
- Saturation: Normal
- Color Balance: 0, 0, 0
- Color Shift: Normal
• After finishing the auto calibration, change the settings of [Copy Defaults] if necessary. For
information on [Copy Defaults], refer to "Copy Defaults" (P.134).
• The default user ID is "11111".
• The default passcode is "x-admin".

Executing Calibration

<Log In/Out> button
79
3