Replacing The Staple Cartridge (For Finisher C2 Or Finisher C2 With Booklet Maker) - Fuji Xerox Color 550 Administrator's Manual

3 Maintenance
Replacing the Staple Cartridge (For Finisher C2 or Finisher C2 with
Booklet Maker)
When the Finisher C2 (optional) or Finisher C2 with Booklet Maker (optional) is
installed and it is time to replace the staple cartridge, a message appears on the touch
screen. When this message appears, replace the staple cartridge.
The following example shows how to replace the staple cartridge in the Finisher C2 with
Booklet Maker. The procedure for the Finisher C2 is the same.
Important • The use of staples not recommended by Fuji Xerox may degrade image quality and
Note
1
Make sure that the machine is not operating,
and open the front cover of the finisher.
3
2
Grip lever R1 of the staple cartridge holder,
and pull out the holder to the right towards
you.
3
Remove the staple cartridge holder by
gripping the orange lever.
Note
4
Grasp the empty staple case with your
fingers (1), and then remove the case from
the cartridge (2) as shown in the figure.
66
performance. Use only staples recommended by Fuji Xerox.
• If the staple cartridge is not replaced properly, the message prompting replacement will
remain displayed. In this case, set the new staple cartridge again by performing the following
procedure one more time from the beginning.
• To order a staple cartridge, contact your local Fuji Xerox representative.
• The staple cartridge is firmly set in place.
Removing the cartridge may require
pulling on the cartridge with slight force.
Lever (R1)
Orange lever
2
1
1