Fuji Xerox Color 550 Administrator's Manual page 110

5 Tools
Allow User to Lock Out
Selecting [Lock Out Printer] on the [Services Home] screen temporarily disables printing.
[Release Printer] is displayed during the printer lockout duration. Selecting [Release Printer]
enables printing.
Note
Energy Saver Timers
The Energy Saver mode has two modes: Low Power mode and Sleep mode. When a
5
specified period of time has elapsed, the machine switches to these modes in the following
order to reduce power consumption.
Last operation on the machine
For more information on the setting procedure, refer to "Energy Saver Mode" (P.14).
Note
From Last Operation to Low Power Mode
Specify a time period between 1 and 240 minutes in 1 minute increments to enter Low Power
mode after the last operation.
From Last Operation to Sleep Mode
Specify a time period between 1 to 240 minutes in 1 minute increments to enter Sleep mode
after the last operation.
Note
Time Zone
Set the time difference from GMT between -12 and +12 hours.
Note
Daylight Savings
You can set daylight saving time. During daylight saving time period, the machine moves the
clock forward by one hour.
Select from [Adjust Off], [Adjust by Month, Day & Time], and [Adjust by Month, Week, Day of
Week & Time].
If you select [Adjust by Month, Day & Time], specify the month, day, and time for [Start Date]
and [End Date].
If you select [Adjust by Month, Week, Day of Week & Time], specify the month, week, day of
week, and time for [Start Date] and [End Date].
110
• A job started before the start time will be printed continuously even after elapsing the start
time. The job will be printed continuously even if you select [Lock Out Printer] while printing.
After the job is completed, the machine enters the printer lockout status.
• When both [Set Lockout Duration] and [Allow User to Lock Out] are set and the start time
comes while the [Release Printer] button is displayed, the machine automatically enters the
printer lockout status.
• When you select [Release Printer] during the printer lockout duration, printing is enabled,
and when you then select [Lock Out Printer], the machine resumes the printer lockout status.
• The printer lockout status is not released automatically even after the end time has elapsed.
To release the printer lockout status, the control panel operation is required.
• The printer lockout duration will not be released even when you switch the power off and
then on again, or even when you press the <Energy Saver> button while the machine is in
the Energy Saver mode (Low Power mode or Sleep mode).
• The machine starts printing in accordance with the setting in [Auto Print] when [Release
Printer] is selected. Thus printing may not start immediately after [Release Printer] is
selected.
• You can also print during the printer lockout duration by selecting a job in [Active Jobs] on
the [Job Status] screen and then selecting [Promote Job].
Low Power mode
• You cannot configure the machine not to switch to Low Power mode or Sleep mode.
• Configure the [From Last Operation to Sleep Mode] time to be longer than the [From Last
Operation to Low Power Mode] time.
• GMT stands for Greenwich Mean Time.
Sleep mode