Fuji Xerox Color 550 Administrator's Manual page 202

7 Problem Solving
Error Code
016-774 [Cause]
[Remedy] Delete unnecessary data from the hard disk to free up disk space.
016-775 [Cause]
[Remedy] Delete unnecessary data from the hard disk to free up disk space.
016-777
[Cause]
[Remedy] The hard disk may be defective. To replace the hard disk, contact your local Fuji
016-778
[Cause]
[Remedy] Delete unnecessary data from the hard disk to free up disk space.
016-779
[Cause]
[Remedy] Retry scanning. If using large-size paper such as A3 with [Resolution] set to [600
016-780
[Cause]
[Remedy] The hard disk may be defective. To replace the hard disk, contact your local Fuji
016-786
[Cause]
[Remedy] Either remove unnecessary data from the hard disk to increase free disk space, or
016-791
[Cause]
[Remedy] Check whether you can access the specified forwarding destination.
7
016-792 [Cause]
[Remedy] The specified job history does not exist.
018-571
[Cause]
[Remedy] Perform the same operation again. If the problem persists, contact your local Fuji
021-210
[Cause]
[Remedy] Check the USB IC card reader connection. Then, switch off the machine power,
021-211
021-213
021-360
[Cause]
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then
021-361
021-750
[Cause]
021-751
[Remedy] Confirm that the telephone line is connected and retry after waiting for a while.
021-770
021-771
021-772
* If you cannot resolve an error despite following the instructions described in the table, contact your local Fuji Xerox
representative. The contact number is printed on the label or card attached on the machine.
202
Cause and Remedy
Unable to process compression conversion because of insufficient hard disk
space.
Unable to process image conversion because of insufficient hard disk space.
A hard disk error occurred during image processing.
Xerox representative.
The conversion processing of the scanned image was interrupted because of
insufficient disk space.
An error occurred during scanned image conversion processing.
dpi], specify [Resolution] to [400 dpi] or lower in [Layout Adjustment]. If the error
still is not resolved, contact your local Fuji Xerox representative.
A hard disk error occurred during scanned image conversion processing.
Xerox representative.
When using the scan feature, available hard disk space is insufficient for writing to
a file.
initialize the hard disk.
The forwarding destination or job template save location could not be accessed.
Specific job history could not be acquired when printing [Job Report].
An internal error occurred.
Xerox representative.
An error occurred with the USB IC card reader.
make sure that the touch screen is blank, and then switch on the machine power.
If the error is not resolved, the USB IC card reader may be broken. Connect a
USB IC card reader that is not broken, and switch on the machine power again.
An error occurred.
switch on the machine power. If the same message is displayed again, contact
your local Fuji Xerox representative.
An error occurred during maintenance or repair request and your local Fuji Xerox
representative failed.
If the error code is displayed again, contact your local Fuji Xerox representative by
telephone.