Snmp Settings; Snmp Notify Type Settings - Motorola 2200 Administrator's Handbook

SNMP Settings

The Simple Network Management Protocol (SNMP) lets a network administrator monitor problems on a net-
work by retrieving settings on remote network devices. The network administrator typically runs an SNMP
management station program on a local host to obtain information from an SNMP agent such as the Motor-
ola Netopia® Gateway.
set snmp community read name
Adds the specified name to the list of communities associated with the Motorola Netopia® Gateway. By
default, the Motorola Netopia® Gateway is associated with the public community.
set snmp community write name
Adds the specified name to the list of communities associated with the Motorola Netopia® Gateway.
set snmp community trap name
Adds the specified name to the list of communities associated with the Motorola Netopia® Gateway.
set snmp trap ip-traps ip-address
Identifies the destination for SNMP trap messages. The ip-address argument is the IP address of the
host acting as an SNMP console.
set snmp sysgroup contact contact_info
Identifies the system contact, such as the name, phone number, beeper number, or email address of the
person responsible for the Motorola Netopia® Gateway. You can enter up to 255 characters for the
contact_info argument. You must put the contact_info argument in double-quotes if it contains
embedded spaces.
set snmp sysgroup location location_info
Identifies the location, such as the building, floor, or room number, of the Motorola Netopia® Gateway. You
can enter up to 255 characters for the location_info argument. You must put the location_info
argument in double-quotes if it contains embedded spaces.

SNMP Notify Type Settings

set snmp notify type [ v1-trap | v2-trap | inform ]
Sets the type of SNMP notifications that the system will generate:
• v1-trap – This selection will generate notifications containing an SNMPv1 Trap Protocol Data Unit (PDU)
• v2-trap – This selection will generate notifications containing an SNMPv2 Trap PDU
•
inform – This selection will generate notifications containing an SNMPv2 InformRequest PDU.
297