Factory Default Settings For The Motorola Cellular Gateway Nc800 - Motorola NC800 User Manual

encryption, performance and compatibility.
The Motorola Cellular Gateway NC800 contains extensive mechanisms to protect your
Firewall
network against intruders and abuse. Use the settings under this heading to prevent certain
types of packets from entering / leaving your network and also to restrict access to specific
users.
Access to all logging screens.
Logging
Restore factory defaults and upgrade the Motorola Cellular Gateway NC800's firmware.
Administration
Access to Diagnostics pages. Usually triggered when prompted by service personnel
Diagnostics
You can move into more detailed configuration settings by selecting a specific category.
Important buttons:
Every page has a Help button. Press this button to have the Motorola Cellular Gateway NC800
open a new window containing detailed help on the current configuration page.
Most pages have an Apply button. Once you have made all the changes that you require click on
this button to apply the new settings. The Motorola Cellular Gateway NC800 verifies the settings
and lets you know if there are any problems. Applying settings typically takes about 5 seconds to
complete as the Motorola Cellular Gateway NC800 needs to re-initialize parts of its software
according to the changes that you have made. Closing or moving on to other menus will not apply
the modified settings.
Most pages have a Reset button. If you have made any changes that you do not want to save, click
on the Reset button to reset the settings on the current page to those that were there when you
entered the page.

Factory Default Settings for the Motorola Cellular Gateway NC800

Please take note of the following factory default settings. Out of the box, the Motorola Cellular Gateway NC800
is configured with these commonly used settings. If you ever need to use the Motorola Cellular Gateway
NC800's Administration->Restore function, these are the settings that will be restored (this can also be
achieved by pressing the reset button on the rear panel and holding it down for 10 seconds):
Gateway Mode
LAN Spanning Tree
Firewall
Wireless Interface
WAN Interface
LAN DHCP Server
IP Address
Channel
Country
Network Authentication
Data Encryption
Station Filtering
User Name
Password
Table 1: Default settings for the Motorola Cellular Gateway NC800.
Warning: The settings above are the commonly used defaults. These may differ from one service
provider to another. Please refer to any additional material provided by your service provider.
Motorola Cellular Gateway NC800 User Guide Version 2.0
SSID
Router
Enabled
Enabled
Enabled
Enabled
Enabled
192.168.1.1
Motorola
11
Worldwide
Disabled
Off
Disabled
admin (lower case)
admin (lower case)
Page 28 of 110