Motorola 2200 Administrator's Handbook page 205

1.
2.
3.
EN Traffic Unlit
4.
5.
Note: USB Active light is inactive if only using Ethernet.
1.
2.
USB
Unlit
3.
Active
4.
5.
Launch a browser and try to browse the Internet. If the DSL Active light still does not flash,
DSL
Unlit
then proceed to Advanced Troubleshooting below.
Traffic
•
Wireless
•
Unlit
Link
•
Make sure you have Ethernet drivers installed on the PC.
Make sure the PC's TCP/IP Properties for the Ethernet Network Control Panel is set to
obtain an IP address via DHCP.
Make sure the PC has obtained an address in the 192.168.1.x range. (You may have
changed the subnet addressing.)
Make sure the PC is configured to access the Internet over a LAN.
Disable any installed network devices (Ethernet, HomePNA, wireless) that are not being
used to connect to the 2200-, 3300- or 7000-series DSL Gateway.
Make sure you have USB drivers installed on the PC.
Make sure the PC's TCP/IP Properties for the USB Network Control Panel is set to obtain
an IP address via DHCP.
Make sure the PC has obtained an address in the 192.168.1.x range. (You may have
changed the subnet addressing.)
Make sure the PC is configured to access the Internet over a LAN.
Disable any installed network devices (Ethernet, HomePNA, wireless) that are not being
used to connect to the 2200-, 3300- or 7000-series DSL Gateway.
Make sure your client PC(s) have their wireless cards correctly installed and configured.
Check your client PC(s) TCP/IP settings to make sure they are receiving an IP address from
the wireless Router.
Check the Gateway's log for wireless driver failure messages.
205