Motorola 2200 Administrator's Handbook page 150

Administrator's Handbook
Be sure that you have SafeHarbour VPN enabled.
3.
SafeHarbour is a keyed feature.
Motorola Netopia® Software Feature Keys.
Check the Enable SafeHarbour IPSec
4.
Checking this box will automatically display the SafeHarbour IPSec Tunnel Entry parameters.
Enter the initial group of tunnel parameters. Refer to your Setup Worksheet and the "Parameter
Descriptions" on page 151 as required.
Enter the tunnel Name.
5.
This parameter does not have to match the peer/remote VPN device.
Enter the Peer External IP
6.
Select the Encryption Protocol
7.
Select the Authentication Protocol
8.
Click Add.
9.
The Tunnel Details page appears.
150
See "Install Key" on page 187.
checkbox.
Address.
from the pull-down menu.
from the pull-down menu.
10.
Enter or select the required settings.
Soft MBytes, Soft Seconds, Hard MBytes, and
Hard Seconds values do not have to match the
peer/remote VPN device.
Refer to your
Setup Worksheet" on page
11.
The
12.
13.
Your SafeHarbour IPSec VPN tunnel is fully config-
ured.
for information concerning installing
Make the Tunnel Details entries.
"IPSec Tunnel Details Parameter
Click Update.
Alert
button appears.
Click the Alert button.
Click Save and Restart.
149.)