Factory Reset Switch - Motorola 2200 Administrator's Handbook

Administrator's Handbook

Factory Reset Switch

(not supported on some models; 3342/3342N/3352/3352N models do not have a reset switch)
Lose your password? This section shows how to reset the Motorola Netopia® Gateway so that you can
access the configuration screens once again.
☛
NOTE: Keep in mind that all of your settings will need to be reconfigured.
If you don't have a password, the only way to access the Motorola Netopia® Gateway is the following:
Referring to the following diagram, find the round Reset Switch opening.
1.
MiaVo
DSL
Factory Reset Switch:
Push to clear all settings
3347W/3357W
DSL
4 3
Factory Reset Switch:
Push to clear all settings
3341/3351
Ethernet
2
DSL
Factory Reset Switch:
Push to clear all settings
3346/3356
4
DSL
Factory Reset Switch:
Push to clear all settings
Carefully insert the point of a pen or an unwound paperclip into the opening.
2.
• If you press the factory default button for less than 1/2 a second, the unit will continue to run as nor-
mal.
• If you press the factory default button for 1 second, when you release it, the Gateway will perform a fac-
tory reset, clear all settings and configurations, and reboot. Do not hold the button down too long (5 –
10 seconds). This will destroy any saved default settings as well.
206
LAN
4 3 2 1
Power
Off/On
LAN 2 1 Power Off / On
3 4 1
USB Power
On / Off
3 LAN 2 1
Power Off / On
2247NWG
4 3 2
DSL ETHERNET
Factory Reset Switch:
Push to clear all settings
Factory Reset Switch: Push to clear all settings
2246N
Factory Reset Switch:
Push to clear all settings
ON
OFF
RESET
1
POWER
2240N
2241N