Motorola 2200 Administrator's Handbook page 305

set wireless multi-ssid second-ssid-wepkey { hexadecimal digits }
set wireless multi-ssid third-ssid-wepkey { hexadecimal digits }
set wireless multi-ssid fourth-ssid-wepkey { hexadecimal digits }
Specifies a WEP key for the multiple SSIDs, when second-, third-, or fourth-ssid-privacy is set to WEP.
For 40/64bit encryption, you need 10 digits; 26 digits for 128bit, and 58 digits for 256bit WEP. Valid hexa-
decimal characters are 0 – 9, a – f.
set wireless no-bridging [ off | on ]
When set to on, this will block wireless clients from communicating with other wireless clients on the LAN
side of the Gateway.
set wireless tx-power [ full | medium | fair | low | minimal ]
Sets the wireless transmit power, scaling down the router's wireless transmit coverage by lowering its radio
power output. Default is full power. Transmit power settings are useful in large venues with multiple wire-
less routers where you want to reuse channels. Since there are only three non-overlapping channels in the
802.11 spectrum, it helps to size the Gateway's cell to match the location. This allows you to install a
router to cover a small "hole" without conflicting with other routers nearby.
305