Chapter 6 Command Line Interface - Motorola 2200 Administrator's Handbook

CHAPTER 6 Command Line Interface

The Motorola Netopia® Gateway operating software includes a command line interface (CLI) that lets you
access your Motorola Netopia® Gateway over a telnet connection. You can use the command line interface
to enter and update the unit's configuration settings, monitor its performance, and restart it.
This chapter covers the following topics:
•
"Overview" on page 224
•
"Starting and Ending a CLI Session" on page 226
•
"Using the CLI Help Facility" on page 226
•
"About SHELL Commands" on page 227
•
"SHELL Commands" on page 228
•
"About CONFIG Commands" on page 240
•
"CONFIG Commands" on page 243
"Remote ATA Configuration Commands" on page 243
"DSL Commands" on page 245
"Bridging Settings" on page 246
"DHCP Settings" on page 248
"DMT Settings" on page 254
"Domain Name System Settings" on page 255
"IGMP Settings" on page 257
"IP Settings" on page 259
"Queue Configuration" on page 271
"IPMaps Settings" on page 277
"Network Address Translation (NAT) Default Settings" on
page 278
"Network Address Translation (NAT) Pinhole Settings" on
page 278
"PPPoE /PPPoA Settings" on page 279
"SNMP Settings" on page 297
CONFIG Commands
"PPPoE with IPoE Settings" on page 282
"Ethernet Port Settings" on page 283
"802.3ah Ethernet OAM Settings" on page 284
"Command Line Inter face Preference Settings" on
page 285
"Port Renumbering Settings" on page 286
"Security Settings" on page 287
"System Settings" on page 298
"Syslog" on page 301
"Wireless Settings (suppor ted models)" on page 303
"VLAN Settings" on page 311
"VoIP settings" on page 316
"UPnP settings" on page 321
"DSL Forum settings" on page 321
"Backup IP Gateway Settings" on page 323
223