Displaying Current Gateway Settings; Step Mode: A Cli Configuration Technique; Validating Your Configuration - Motorola 2200 Administrator's Handbook

Administrator's Handbook

Displaying Current Gateway Settings

view
You can use the command to display the current CONFIG settings for your Motorola Netopia® Gate-
view
way. If you enter the
for all enabled functions. If you enter the
node and its subnodes.
Step Mode: A CLI Configuration Technique
The Motorola Netopia® Gateway command line interface includes a step mode to automate the process of
entering configuration settings. When you use the CONFIG step mode, the command line interface prompts
you for all required and optional information. You can then enter the configuration values appropriate for
your site without having to enter complete CLI commands.
When you are in step mode, the command line interface prompts you to enter required and optional set-
tings. If a setting has a default value or a current setting, the command line interface displays the default
value for the command in parentheses. If a command has a limited number of acceptable values, those val-
ues are presented in brackets, with each value separated by a vertical line. For example, the following CLI
step command indicates that the default value is
option (off) [on | off]:
You can accept the default value for a field by pressing the Return key. To use a different value, enter it and
press Return.
You can enter the CONFIG step mode by entering
enter step mode for a particular service by entering
Control-X <Return/Enter> to exit. For example:
Netopia-3000/9437188 (top)>> set system
...
system
name ("Netopia-3000/9437188"): Mycroft
Diagnostic Level (High): medium
Stepping mode ended.
Validating Your Configuration
You can use the validate
entered correctly. If you use the
required settings for all services are present and that settings are consistent.
Netopia-3000/9437188 (top)>> validate
Error: Subnet mask is incorrect
Global Validation did not pass inspection!
You can use the validate
pia® Gateway automatically validates your configuration any time you save a modified configuration.
242
command at the top level of the CONFIG hierarchy, the CLI displays the settings
view
command at an intermediate node, you see settings for that
off
set
CONFIG command to make sure that your configuration settings have been
validate command, the Motorola Netopia® Gateway verifies that all
command to verify your configuration settings at any time. Your Motorola Neto-
and that valid entries are limited to
on
from the top node of the CONFIG hierarchy. You can
set .
service_name In stepping set mode (press
on and off .