Default Syslog Installation Procedure - Motorola 2200 Administrator's Handbook

Administrator's Handbook

Default syslog installation procedure

Access the router via telnet from the private LAN.
1.
DHCP server is enabled on the LAN by default.
The product's stateful inspection feature must be enabled in order to examine TCP, UDP
2.
and ICMP packets destined for the router or the private hosts.
This can be done by entering the CONFIG interface.
• Type config
• Type the command to enable stateful inspection
set security state-insp ip-ppp vcc1 option on
• Type the command to enable the router to drop fragmented packets
set security state-insp ip-ppp vcc1 deny-fragments on
Enabling syslog:
3.
• Type config
• Type the command to enable syslog
set system syslog option on
• Set the IP Address of the syslog host
set system syslog host-nameip <ip-addr>
(example: set system syslog host-nameip 10.3.1.1
• Enable/change the options you require
set system syslog log-facility local1
set system syslog log-violations on
set system syslog log-accepted on
set system syslog log-attempts on
Set NTP parameters
4.
• Type config
• Set the time-zone – Default is 0 or GMT
set system ntp time-zone <zone>
(example: set system ntp time-zone –8
• Set NTP server-address if necessary (default is 204.152.184.72)
set system ntp server-address <ip-addr>
(example:
set system ntp server-address 204.152.184.73
• Set alternate server address
set system ntp alt-server-address <ip-addr>
Type the command to save the configuration
5.
• Type
save
• Exit the configuration interface by typing
exit
• Restart the router by typing
restart
The router will reboot with the new configuration in effect.
302
)
)
)