Printer Settings For Wall Mounting Template - Motorola surfboard sbg901 User Manual

To print the template only, select Current page as the Print Range. Be sure you print the
template at 100% scale. Be sure No Scaling is selected for Scale to paper size.
3. Click OK to print the template.
4. Measure the printed template with a ruler to ensure that it is the correct size.
5. Use a center punch to mark the center of the holes.
6. On the wall, locate the marks for the mounting holes.
7. Drill the holes to a depth of at least 1 1/2 inches (3.8 cm). Use M3.5 x 38 mm (#6 x 11/2 inch)
screws with a flat underside and maximum screw head diameter of 9.0 mm to mount the
SBG901.
8. Using a screwdriver, turn each screw until part of it protrudes from the wall, as shown in the
following illustration.
There must be .10 inches (2.5 mm) between the wall and the underside of the screw head.
9. Place the SBG901 so the keyholes on the back of the unit are aligned above the mounting
screws.
2 Getting Started
This document is uncontrolled pending incorporation in PDM
Figure 24 Printer Settings for Wall Mounting Template
6.0 mm (.24 inches) maximum
2.5 mm (.10 inches).
Figure 25 Wall Mounting Screw Dimensions
9.0 mm (.35 inches) maximum
37