Start Recording (Arm Mode) - NAC Image Technology Memrecam Q1v User Manual

Start Recording (ARM Mode)

After making the recording settings, switch to the ARM mode and start recording.
 Make sure to save the recorded image to the memory before switching to the ARM mode.
 Once switched to the ARM mode, the image saved in the memory is overwritten and deleted.
 Switch to the ARM mode after confirming whether or not deleting the image is acceptable.
■ Switch to the ARM Mode
Press the view/record button in the VIEW mode
 Switching from the VIEW mode to the ARM mode is allowed.
 If switching from the STOP mode to the ARM mode, first switch to the VIEW mode
and then switch to the ARM mode.
 The recording settings cannot be changed in the ARM mode.
 The item list STATUS will show "ARM".
 MODE in the status LED of the rear panel on this unit will light up in purple
(magenta).
(00375)
3-19

Start Recording (ARM Mode)