Set Length Range For Code 128 - Newland HR3250 Marlin User Manual

【Enter Setup】

Set Length Range for Code 128

The scanner can be configured to only decode Code 128 barcodes with lengths that fall between (inclusive) the minimum
and maximum lengths. To accomplish it, you need to set the minimum and maximum lengths.
【Set the Minimum Length (Default: 1)】
If minimum length is set to be greater than maximum length, the scanner only decodes Code 128
barcodes with either the minimum or maximum length. If minimum length is same as maximum length,
only Code 128 barcodes with that length are to be decoded.
Set the scanner to decode Code 128 barcodes containing between 8 and 12 characters:
1. Scan the Enter Setup barcode.
2. Scan the Set the Minimum Length barcode.
Scan the numeric barcode "8". (See the "Digit Barcodes" section in Appendix)
3.
Scan the Save barcode. (See the "Save/Cancel Barcodes" section in Appendix)
4.
5. Scan the Set the Maximum Length barcode.
Scan the numeric barcode "1".
6.
Scan the numeric barcode "2".
7.
8. Scan the Save barcode.
9. Scan the Exit Setup barcode.
**【Exit Setup】
【Set the Maximum Length (Default: 48)】
64