【Enter Setup】
Data Bit
Set the number of data bits to match the Host requirements. The default setting is 8 Data Bits.
**【8 Data Bits】
【7 Data Bits】
Stop Bit
The stop bit(s) at the end of each transmitted character marks the end of transmission of one character and prepares the
receiving device for the next character in the serial data stream. Set the number of stop bits to match the Host requirements.
The default setting is 1 Stop Bit.
**【1 Stop Bit】
**【Exit Setup】
【6 Data Bits】
【5 Data Bits】
【2 Stop Bits】
42