【Enter Setup】
Introduction
Normally, when you scan a barcode, it gets outputted automatically; however, when you do a format, you must use a "send"
command (see the "Send Commands" section) to output data. The maximum size of a data format configuration is 256
bytes, which includes header information. No format can contain more than 50 bytes. By default, the data formatter is
disabled. Enable it when required. If you have changed data format settings, and wish to clear all formats and return to the
factory defaults, scan the Default Data Format code below.
Enable/Disable Data Formatter
Scan the appropriate barcode below to enable or disable the data formatter. By default, the data formatter is disabled.
**【Exit Setup】
Chapter 10 Data Formatter
**【Default Data Format】
**【Disable】
【Enable】
166