Removing The Scnt Unit; Removing The Dcnt Board; Removing The Gear Unit; Removing The Rear Cover - Canon FAX-L380S Series Service Manual

Chapter 3
levers [2] on both sides and release the pressure.
2) Remove four screws [3].
3) Remove the rear cover [4] as you pull it toward you.
[3]
[1]

3.5.4.9 Removing the Rear Cover

/ / FAX-L390
1) Opening the face-up cover [1], and then lower the fixing pressure release
levers [2] on both sides and release the pressure.
2) Remove four screws [3].
3) Remove the rear cover [4] as you pull it toward you.
[3]
[1]

3.5.4.10 Removing the SCNT Unit

/ / FAX-L390 / / / FAX-L380S
1) Remove the flat cable [1] on the SCNT board. As you disengage the claw
[2], remove the motor cover [3].
[3] [1]
[2]
F-3-295
2) Remove the four connectors [1] and the flat cable [2].
3) Remove the five screws [3] and the SCNT unit [4].
3-42
[2]
[3]
[4]
F-3-293
[2]
[3]
[4]
F-3-294
[4]
[3]
F-3-296

3.5.4.11 Removing the DCNT Board

0011-6342
/ / FAX-L390 / / / FAX-L380S
1) Take the flat cable [1] off the cable guide.
2) Remove the screw [2] and remove the switch cover [3].
F-3-297
3) Remove the seven connectors [1] and the two flat cables [2].
4) Free the cable from the cable retainer [3].
5) Remove the three screws [4] and, while carefully watching the sensor flag,
remove the DCNT board [5].
0011-6343
[4]
[1]
F-3-298

3.5.4.12 Removing the Gear Unit

/ / FAX-L390 / / / FAX-L380S
1) Remove the two screws [1], and detach the drive plate (small) [2].
[3]
[2]
[1] [3]
[3]
[2]
[1]
[1] [2] [4]
[5]
[1]
[3]
[1] [2] [4]
0011-4813
0011-4814