Aging Test; Faculty Test; Faculty Tests; Sensor Tests - Canon FAX-L380S Series Service Manual

Chapter 5
Memo
The transmission level for each baud rate and speed follows the service data.

5.5.11.5 Aging Test

5.5.11.5.1 AGING Test
/ / FAX-L390 / / / FAX-L380S
The AGING test is selected by pressing the numeric button 5 from the test mode menu. In this test, the contact sensor LED is lit, and the document read motor
driven in fine mode. Also, the printer will fine print a endurance pattern.
The AGING test will end after the output of the printer is halted by pressing the Stop button.

5.5.11.6 Faculty Test

5.5.11.6.1 FACULTY Tests

/ / FAX-L390 / / / FAX-L380S
The faculty tests are selected by pressing the numeric button 6 from the test mode menu.
These tests test the following faculties of this fax.
Test type

Sensor tests

Operation panel test
Line signal reception test
5.5.11.6.2 Sensor Tests
/ FAX-L390 / FAX-L380S
The sensor test is selected by pressing the numeric button 3 from the faculty test menu. In this test, you can check the status of each sensor of this fax in items 1 to
4 on the display.
You can also check if sensors that use actuators and microswitches are operating correctly by moving the actuator or microswitch.
5-34
Search button Speed
< > 26.4 kbps
24.0 kbps
21.6 kbps
19.2 kbps
16.8 kbps
14.4 kbps
12.0 kbps
9.6 kbps
7.2 kbps
4.8 kbps
2.4 kbps
T-5-38
Overview
Test whether the sensors are operating correctly.
Tests whether the button switches on the control panel are operating
correctly.
Tests whether the NCU board signal sensor and frequency counter are
operating correctly.
0011-5291
0011-5292
0011-9451