Installation Of The Lattice Reader - Centsys Lattice Installation Manual

Installation of the Lattice Reader

Installation of the Lattice Reader
Positioning the Reader
1A
Position LATTICE reader on wall
adjacent to door. Mount at a height
that allows for the comfortable
presenting of access tags. A height
of 1300mm is recommended.
If a second reader is mounted on the
inside of the door, it must be spaced
at least 300mm above or below the
outside reader to prevent interfe-
rence.
Mounting the Reader
The LATTICE Prox reader is available in a flush mount kit and a surface mount kit.
When flush mounting, the reader adapts directly to a standard 100mm x 50mm (4" x 2") light switch
backing box which allows the unit to sit flat against the wall.
Alternatively, if no backing box has been provided the unit can be surface mounted.
When mounting the reader onto a gooseneck with, or without, an anti-knock shield, the surface mount kit
will be used.
Flush Mount
1F 2
Insert the reader mounting frame into
position in the backing box and
secure using the standard fixing
screws provided with the backing
box.
1B
300mm
1300mm
Alternatively mount the proximity
reader onto a gooseneck ensuring
that:
• The reader does not protrude too
far into the driveway
• The reader is not set too far back
and cannot easily be accessed
from a vehicle.
• The height allows for the presenting
of the tag to be comfortable from a
vehicle.
An anti-knock shield is available
from CENTSYS to provide extra
protection to the LATTICE reader.
2F 3
It is recommended that the cabling to
the reader extends at least 100mm
through the frame.
1100mm
320mm
100mm
Page 9
1C
Position the LATTICE reader on wall
adjacent to entrance gate. Mount at a
height that allows for the comfortable
presentation of access tags. A height
of 1300mm is recommended.
1300mm 1300mm