Centsys Lattice Installation Manual page 25

Description of QUIK
6 Present and remove the second tag to be learned.
7a
On presentation of the second tag the display indicates the ID number into which
this tag has been learned. Eg. 002
7b On removal of the tag the display reverts back to "Lrn" indicating that the next
tag can be learned.
TM
Table 3. Quik Learn Description
NOTE:
If tags are numbered make sure they are presented to the L1000 in the correct
order.
When first used, the ID number starts at 001 if the QUIK learn feature is invoked.
If tags already exist in memory, then Quick learn will start from the next available
ID number.
The QUIK learn feature will set factory defaults only, and none of the advanced
functionality will be learned. Thus tags will have the following basic functionality:
Tags are learned, automatically, into any LSH active on the system at the
time of programming.
Tags will operate the main relay on the L1000 and LSH's.
There is no anti-pass back.
No limited uses counters are set.
Relay 1 of the L1000 will operate by default for a 3 second pulse.
There is an alternative way to enter new tags which provides the ability
to set all the attributes for a tag. The menu structure is shown in Figures 21 and 22.
NOTE: The "ID Selection" symbol (Figure 17) appears in various levels of the menus
described hereafter. This symbol indicates:
the display will count up or down as the "Admin" tag is presented and removed.
if the green LED is ON, then the count increases as the tag is presented.
If the red LED is ON, then the count decreases as the tag is
presented.
the red and green LED's alternate if a tag is not presented.
if the tag is presented and held in place, then the count rate
increases radically.
This same process applied to setting relay times (See Configure
Menu on page 38)
TM
Learn procedure continued from previous page
Page 24
Fig 17
"ID Selection" symbol