Centsys Lattice Installation Manual page 66

• "---" -(if exit to the previous level is required) (The selection is made by presenting and
removing the "Admin" tag. )
6.6. The various options in level 5 depend again on what is selected in level 4. For example:
6.6.1. Depending on whether CH.1 or CH.2 is selected in the ASC sub-menu then its associated
relay can be set to be "On" or "OFF" by scrolling vertically through the options.
• On - (Relay is turned ON)
• OFF - (Relay is turned OFF)
•"---" - (if exit to the previous level is required) (The selection is made by presenting and
removing the "Admin" tag. )
6.6.2. Depending on whether CH.1 or CH.2 is selected in the ASC sub-menu then its associated
relay can be set to be "On" or "OFF" by scrolling vertically through the options.
• On - (Relay is turned ON)
• OFF - (Relay is turned OFF)
•"---" - (if exit to the previous level is required) (The selection is made by presenting and
removing the "Admin" tag. )
6.6.3. Depending on which of the "APb" levels L.01 to L.07 was previously selected in the Ltd
menu, the choice of whether this reader is at the "entrance" or "exit" to an APB zone,
defined by the "In" or "Out" selection respectively is made by scrolling vertically through
the options
• On - (Entering APB level)
• OFF - (Exiting APB level)
• "---" - (if exit to a previous level is required) by presenting and removing the
"Admin" tag for 5 seconds.
6.6.4. Depending on which of the counters C.01 to C.04 was previously selected in the Ltd
menu, the choice of whether this counter must be operational for this reader is selected
by scrolling vertically through the options
• On - (Counter will be operational at this Lead)
• OFF - (Counter will not be operational at this Lead)
• "---" - (if exit to a previous level is required) (The selection is confirmed by presenting
and holding the "Admin" tag for 5 seconds.)
Once "Con" and, optionally, heads H.01 to H.31 are set, it is critical that -A- in level 2 (see
section 3.2) is selected (i.e. present and hold the "Admin" tag) to save all the settings that
may have been made to levels 3 onwards to the template. The system will exit back to level
1 and display "USr".
6.7. If "Id" was selected in level 1 (by presenting and holding the "Admin" tag for 5 seconds) then the
system will have moved to level 2 and the display will show "000".
6.7.1. Use the "Admin" tag and the red and green LED's to scroll up, or down, to the ID which will
used to generate the template. NOTE: the template information is taken from the first tag
that exists in this ID. Remember that it is possible to have multiple tags within a single ID and
each tag could have different information stored on it.
6.7.2. Once the correct ID has been chosen wait for approximately 5 seconds after which the
display will indicate "Set"
6.7.3. Present and hold the "Admin" tag for 5 seconds and the template information will be saved
and the display reverts to "Id".
6.8. If "tAg" was selected in level 1 (by presenting and holding the "Admin" tag for 5 seconds) then the
system will have moved to level 2 and the display will show
6.8.1. Presenting an existing tag. The information on this tag will be copied into the template
memory, and the display will revert back to "tAg".
Page 61