Basic Menu; Quik Learn - Centsys Lattice Installation Manual

Basic Menu

The Basic Menu comprises the following sub-menu: -
• Lrn - Learn (Quik-Learn & Basic Learn)
• dEL - Delete
• CFg - Configure
• "---" - Exit to Previous Menu
Each of these menus is described in more detail below.
Basic Learn Menu
There are two learn mechanisms that exist under this menu. The first is Quik
automatically learns in a tag to all heads which are active on the RS485 bus at the time of learning
the tag. The second learn method enables tags to be learnt into specific Id's and into specific
heads.

Quik Learn

1.
The QUIK learn feature enables new tags to be entered very quickly into the system. The
flow diagram below shows the QUIK Learn Procedure and is described fully below:
Icon
No
1 The display "Ad1" indicates that the system is in normal RUN mode and that a
correct Admin tag is being presented. The system cannot be programmed if any
tag other than the Admin tag is presented.
Present and Hold the Admin tag for 5 seconds.
2
The display changes to "Lrn" to indicate the system is in Learn mode.
3
Present and remove the first new tag to be learnt into the system.
4
On presentation of the first tag the display indicates the ID number into which this
5a
tag has been learned. Eg. 001
On removal of the tag the display reverts back to "Lrn" indicating that the next tag
5b
can be learned.
TM
TM
1 2
4 5a
6 7a
Description of QUIK
TM
TM
Quik Learn
At this stage the system is ready to
3
have new tags learned in
Tag 1 has now been learned into ID
5b
Number 001
7b
Tag 2 has now been learned in, etc, etc.
TM
Learn procedure shown above
Page 23
TM
Learn which