Centsys Lattice Installation Manual page 11

8 Optional cable tie
B
B
B
If the additional cable tie was used,
make certain that it is also tightened.
10
Ensure that it sits neatly against the
cable entry bulkhead securing the
cable. To prevent insect ingress use
either a grommet or a dab of silicon
to seal the cable entry point.
13
Clip the outer cover into position
making sure that it seats correctly
and is secure.
8 C
Ensure Jumpers 1 and 2 are
correctly positioned - refer to Figure
1 on page 12.
A
11
B
Clip the top of the controller front
housing into the top lip of the
mounting frame (A), and fold down
into position ensuring the cable is not
caught (B).
14
To remove the outer cover, carefully
insert a screwdriver between the
c o v e r a n d t h e w a l l f r o m t h e
underneath and unclip.
Page 11
9
Jumper 2
Jumper 1
Slide the back cover onto the
controller housing.
12
Fasten controller housing into
position using the 2 x M4 pan head
screws provided in the kit.