Centsys Lattice Installation Manual page 10

Surface Mount
1S
Clip the plastic spacers onto the
back of the mounting frame ensuring
that they are correctly orientated to
align with the mounting holes.
Installation of the Reader (Flush or Surface Mount)
4
Slide apart the front and back of the
reader controller housing.
7
Fit a cable tie around the cable as
shown. When tightened this holds
the cable in position and prevents it
from being pulled out of the housing.
2S
Place the mounting template located
in the centre of this document at the
required height ensuring that it is
vertical
Using a 5mm masonry bit, drill holes
into the wall for the rawlplugs
provided in the kit.
Screw the frame lightly into position.
5
Make the necessary terminations
onto the controller. Refer to wiring
diagram on pages 14-16.
8
Tighten cable tie.
Page 10
3S
Using the slots provided in the
mounting holes, adjust the reader
base to be perfectly vertical.
Screw the frame firmly into position.
6
Route the cable over the cable entry
b u l k h e a d ( A ) i n t h e h o u s i n g .
Additional slots can be cut out to
accommodate further cables if
necessary.
8 Optional cable tie
B
B
An additional cable-tie can be fitted
to better secure the cable.
A