Basic Configure - Centsys Lattice Installation Manual

2.3.2. ErA - (Erase All) Present and hold the "Admin" tag for 5 seconds to move
NOTE: During a bulk erase (ErA) even the master or "Admin" tag is erased from the system.
This means that a new "Admin" tag will have to be created before the system can be used. (See
First Time Operation.

3. Basic Configure

The Configure Menu enables the "Advanced Menu" structure to be invoked. The advanced menu
structure will remain in effect for approximately twenty minutes and then revert back to BASIC.
The Configure menus are described fully below referring to the BASIC Configure menu (Figure 20)
Fig 20 Basic "Configure" Menu Structure
2.3.1.2. Present and remove the "Admin" tag. The Display will FLASH
"dNE" momentarily (abbreviation for Done) to indicate that any tag
(or tags) stored in the selected ID have been deleted. The system
goes back to level 1 to allow the process to be repeated.
from "ErA" to "No"
2.3.2.1. Present and remove the "Admin" tag to scroll vertically through
the options:
No - No, do NOT erase all tags.
Yes - Yes, erase all tags.
"---" - Exit to previous menu.
2.3.2.2. Present and hold the "Admin" tag when the option in 2.3.2.1. has
been selected.
• If No was selected the system will not erase tags and returns to
the ErA display.
• If YES was selected the display will momentarily flash up "bSY"
(an abbreviation for Busy) and then "dNE" (an abbreviation for
Done) to indicate that all tags have been erased.
• If "---" was selected the system will not erase tags and returns to
the dEL display.
Basic "Configure" Menu Structure
Main Level 1
to top of Level
Page 27
Level 2
of the options
to top of Level
select one
or exit