Basic Learn - Centsys Lattice Installation Manual

Basic Learn:

1.2.
The Basic learn process is described below with reference to the "Basic" Learn Menu
Structure diagram (See Figure 18).
1.2.1. Present and hold the "Admin" Tag for 5 seconds to move from LRN of the main
1.2.2. Present and remove the "Admin" Tag in association with the Red and Green
1.2.3. Present and remove a new tag. The display will change to "Con" (Controller)
1.2.4. Present and remove the "Admin" tag to scroll vertically through the available
1.2.5. Once the required head in 1.2.4. is selected, present and remove the NEW tag
1.2.6. Confirm the setting decided upon in 1.2.5. above by repeatedly presenting
1.2.7 Present and hold the new tag for 5 seconds to save the new tag. The display
Main
Fig 18 Basic "Learn" Menu Structure
menu to "000" of Level 1.
LED's on the L1000 to scroll the ID Number up or down to the required ID Number
for the new tag which has to be learned in. (In this example 006)
heads, "Con" and "H.01" to "H.31". Only heads currently active on the bus will be
displayed.
while monitoring the red and green LED on the L1000. Each time the tag is
removed the LEDs will toggle. If the Red LED is ON it means that the tag will not
operated on this head and if the Green LED is ON the tag will operate on this
head.
and removing the "Admin" tag to scroll vertically down to -A-
will momentarily flash"dNE" to indicate that the new tag has been saved. To
learn additional tags, or wait 10 seconds for the systems to time out.
NOTE: If the "Admin" tag is presented and held at -A- the system will exit to Lrn.
Basic "Learn" Menu Structure
Level 1
Option 2:
Exit back to Main Menu
if the Admin Tag is used
Level 2
Flashes
message
momentarily
Option 1:
Saves New tag
& returns to process
next tag
Page 25
Level 3
Toggle LED to
associate tag
with the reader
(Grn=Yes
Red= No
Option 3:
Return to
top o f Level 3