Kubota RTV 900 Workshop Manual page 28

RTV900, WSM
VHT Pressure Release Cable
1. Loosen the lock nut (2) and remove the VHT pressure release
cable (1) from the bypass link 1 (3).
(When reassembling)
NOTE
• When adjusting the cable tension, take care not to apply
excessive tension.
• Adjust the length of the cable outer section so that the cable
(1) has no play, and tighten the lock nut.
(1) VHT Pressure Release Cable
(2) Lock Nut
Tension Spring of VHT Pressure Release Link
1. Remove the tension spring (4) from the bypass link 2 (5).
2. Remove the clevis (2) from brake cam lever (1).
(When reassembling)
NOTE
• Before adjusting the tension spring (4), be sure to complete
adjustment of the brake rod.
• Adjust the length of tension bolt (3) to remove allowance of
the tension spring (4). By adjusting the length of the tension
bolt (3), remove allowance of the tension spring (4). (To
adjust the length, the tension spring (4) must be removed
from the link to turn the tension bolt (3).)
• After removing allowance of the tension spring (4), remove
the tension spring (4) once and rotate the bolt clockwise by
one turn. (A slight tension is given to the tension spring (4).)
(1) Brake Cam Lever
(2) Clevis
(3) Tension Bolt
Power Steering Hose and Radiator Hose (Lower)
1. Remove the power steering suction hose (3) and delivery hose
(4).
2. Disconnect the fuel hose (2).
3. Disconnect the radiator hose (lower) (1).
(1) Radiator Hose (Lower)
(2) Fuel Hose
9-S6
NEW TRANSMISSION
(3) Bypass Link 1
W1014737
(4) Tension Spring
(5) Bypass Link 2
W1014583
(3) Suction Hose
(4) Delivery Hose
W1015069
KiSC issued 04, 2006 A