Checking, Disassembling And Servicing; Checking; Preparation; Rear Axle Bracket Assembly - Kubota RTV1140CPX Workshop Manual

RTV1140CPX, WSM

3. CHECKING, DISASSEMBLING AND SERVICING

[1] CHECKING

[2] PREPARATION

(1) Rear Axle Bracket Assembly

Checking Shock Absorber
1. Visually check the shock absorber (1) for breaks or distortion.
2. If the shock absorber is damaged in any way, replace it.
3. Check for oil leakage at the shock absorber.
4. If oil leakage is noted, replace it.
5. Push, and shorten the shock absorber, and check whether to
return in former state.
6. Replace the shock absorber for the new one if it does not return
to former state.
7. Visually check the rubber bush in the upper and lower
mountings of the rear shock absorber.
8. If they are worn, cracked, hardened, or otherwise damaged,
replace them with new one.
(1) Shock Absorber
Cargo Bed
1. Lift up the cargo bed (1) by hand and support it with the safety
support so that the hydraulic cylinder should not drop.
2. Remove the cotter pin and clevis pin (2).
3. Disconnect the connector (3) from main harness, then separate
the harness for the tail lamps.
4. Loosen the lock nut (4) and remove the hinge bolt (5) and nut.
(1) Cargo Bed
(2) Clevis Pin
(3) Connector
3-S3
REAR AXLE
9Y1210293RAS0003US0
(4) Lock Nut
(5) Hinge Bolt
9Y1210293ENS0001US0
KiSC issued 05, 2014 A