IBM eserver xSeries 350 User Reference Manual page 62

The following illustration shows the rear connectors on the SCSI repeater card, as
viewed from the rear of the server.
SCSI repeater
card cable
connector
To install a 3-Pack Ultra160 Hot-Swap Expansion Kit:
Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see "Handling
static sensitive devices" on page 40.
1.
2.
3.
4.
50
IBM® xSeries 350: User's Reference
Review the information in "Before you begin" on page 39 and in "Safety" on page
v.
Turn off the server and peripheral devices and disconnect all power cords and
external cables; then, remove the top cover (see "Removing the server top cover
and bezel" on page 41).
See the documentation that comes with the option to assemble the hot-swap
expansion option.
Align the hot-swap expansion option with the empty slot at the rear of the
optional hard disk drive cage, adjacent to the standard hot-swap hard disk drive
backplane.
SCSI cable
connector
SCSI power
cable connector
2
I C cable
connector
SCSI power
cable
connector
2
I C cable
connector
SCSI cable
connector