Recovering Bios - IBM eserver xSeries 350 User Reference Manual

Code Function
302 Mouse
305 Video monitor
405 Ethernet
415 Analog/digital
modem

Recovering BIOS

104
IBM® xSeries 350: User's Reference
Result
Failed On system board pointing device test failed.
Any message
Failed In PCI slot n
(where n is the PCI slot number in which the
failing Ethernet adapter is installed)
On system board
Not applicable No modem was detected
PCI modem detected but not enabled
Failed Modem reset failed
No dial tone detected
If your BIOS has become damaged, such as from a power failure during a flash
update, you can recover your BIOS using the flash ROM page swap jumper (J14) and
a BIOS flash diskette.
Text message Action
Replace the pointing
device. If the problem
persists, call for service.
Refer to the information
that comes with the
monitor.
Replace the Ethernet
adapter in slot n. If the
problem persists, call for
service.
Call for service.
1. Verify that the
modem is properly
attached to the
server.
2. If the problem
remains, replace the
modem.
If the problem persists,
call for service.
1. Change the
configuration to
enable the modem.
2. If the problem
remains, replace the
modem.
If the problem persists,
call for service.
Replace the modem.
If the problem persists,
call for service.
1. Make sure that the
phone line attached
to the modem has a
dial tone. (Connect a
phone to the line and
listen, if necessary.) If
there is no tone, have
the phone line
serviced.
2. If the problem
remains, replace the
modem.
If the problem persists,
call for service.