3
A
Use the tab
on the rear of the slide rail to
A
align the slide rail to the rack. If it is necessary
to adjust the slide rail, loosen the screws
the rear of the rail.
5
B
Use the hinge pin
to attach the cable-
A
management arm
B
B
B
A
to the hinge bracket.
4
Use the M6 screws to bolt the slide rail to the
front of the rack (left front of rack
Then, use the M6 screws to b
on
and the hinge bracket on the right rear of the
rack. Keep the hinge bracket as vertical as
possible to prevent the cable management
arm from sagging. If you loosened the screws
at the rear of the slide rail, tighten them now.
Repeat the slide-rail-installation instructions
for the other slide rail.
6
Caution: To avoid injury, do not place your
fingers around the rack-support wheels
when lowering the server onto the rails.
Fully extend the slide rails out of the rack.
Lift the server above the rails; then, rest
rack-support wheels
Chapter 7. Rack installation instructions
shown here).
olt the slide rail
A
A
on the slide rails.
A
A
139