IBM eserver xSeries 350 User Reference Manual page 100

Table 16. POST error messages.
POST message
289 An error occurred during POST memory tests and a failing DIMM was disabled.
Note:
Action: 1.
If the problem persists, call for service.
301 An error occurred during the keyboard and keyboard controller test. These error messages also
303 might be accompanied by continuous beeping.
Action: Ensure that:
Running the diagnostic tests can isolate the server component that failed, but you must have
your system serviced. If the error message remains, call for service.
Note:
602 Invalid diskette boot record
Action: 1.
If the problem persists, call for service.
604 An error occurred during a diskette drive test.
Action: 1.
662 A diskette drive configuration error occurred.
Action: If you removed a diskette drive, make sure that the diskette drive setting is correct in the
If the problem persists, call for service.
962 A parallel port configuration error occurred.
Action: If you changed a hardware option, make sure that the parallel port setting is correct in
If the problem persists, call for service.
88
IBM® xSeries 350: User's Reference
You can use the server with decreased memory.
If you just installed memory, verify that the new memory is correct for your server.
Also verify that the memory is installed and seated correctly. Start the
Configuration/Setup Utility program and select Memory Settings from the
Advanced Setup menu to enable the DIMM.
2. If the problem remains, replace the failing DIMM.
• Nothing is resting on the keyboard and pressing a key.
• No key is stuck.
• The keyboard cable is connected correctly to the keyboard and to the correct
connector on the server.
If you just connected a new mouse or other pointing device, turn off the server and
disconnect that device. Wait at least 5 seconds; then, turn on the server. If the error
message goes away, replace the device.
Replace the diskette.
2. If the problem persists, make sure that the diskette drive cables are correctly and
securely connected.
3. If the problem remains, replace the diskette drive.
Verify that the Configuration/Setup Utility program correctly reflects the type of
diskette drive that you have installed.
2. Run the diagnostic tests. If the diagnostic tests fail, call for service.
Configuration/Setup Utility program. If the setting is not correct, change it.
the Configuration/Setup Utility program. If the setting is not correct, change it.
Description