Device Driver Messages - IBM eserver xSeries 350 User Reference Manual

Network driver interface specification 2.01
(OS/2) device driver messages
This section provides explanations of the error messages for the NDIS 2.01 (OS/2)
device drivers and suggested actions to resolve each problem.
Table 21. NDIS 2.01 (OS/2) driver messages for the Ethernet controller.
PCNTND-1 Unable to open the Protocol Manager.
Explanation: The NDIS stack is not configured correctly.
Action: Check and correct your configuration.
PCNTND-6 Out of memory while allocating buffers.
Explanation: The driver could not allocate the requested buffers.
Action: Check your system configuration. Edit the PROTOCOL.INI file to reduce the
number of Txbuffers and Rxbuffers specified for the driver.
PCNTND-7 A Protocol Manager device error occurred.
Explanation: The NDIS stack is not configured correctly.
Action: Check and correct your configuration.
PCNTND-8 Bad status for the Protocol Manager.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
PCNTND-9 Cannot find the PROTOCOL.INI entry.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
PCNTND-10 The Protocol Manager Input Output Control (IOCTL) failed.
Explanation: The NDIS stack is not configured correctly in the PROTOCOL.INI file.
Action: Check and correct your configuration.
PCNTND-11 Protocol Manager registration failed.
Explanation: The NDIS stack is not configured correctly.
Action: Check and correct your configuration.
PCNTND-15 Device not found.
Explanation: The device driver cannot find an Ethernet controller in the server.
Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled, go
to "Starting the diagnostic programs" on page 96 to run the diagnostic programs.
PCNTND-16 PCI scan specified, device not found.
Explanation: The device driver cannot locate the Ethernet controller on the PCI bus.
Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled, go
to "Starting the diagnostic programs" on page 96 to run the diagnostic programs.
PCNTND-21 The adapter failed the checksum test.
Explanation: The device driver cannot find an Ethernet controller.
Action: Verify that the Ethernet controller is enabled. If the Ethernet controller is enabled, go
to "Starting the diagnostic programs" on page 96 to run the diagnostic programs.
122
IBM® xSeries 350: User's Reference