Sensor Calibration With White Paper - Toshiba DB-EA4D SERIES Owner's Manual

5. PRINTER SETUP

5.7.2 SENSOR CALIBRATION WITH WHITE PAPER

This mode performs Sensor level adjustment test with white paper.
Sequence:
1. Select "Sensor Calibration" in main menu of
Menu Mode,
And Press [FEED] key shortly.
A message appears on the LCD, as shown below.
Calibration with
BM Paper
2. Select "Calibration with White Paper".
And press [FEED] key shortly.
A message appears on the LCD, as shown below.
Remove paper
Press FEED key
3. Remove paper and roll paper.
4. Press [FEED] Key shortly.
A message appears shortly
on the LCD, as shown below.
Calibration
Performing...
5. After the calibration with no paper was performed, a message appears on the LCD as shown
below.
Set BM paper
Press FEED key
6. Set white paper in the printer.
And insert the paper into the printer without thermal print head unit ope
n.
7. Press [FEED] Key shortly.
8. Starts loading and feeding a paper, and starts the calibration with white paper.
A message appears on the LCD as shown below.
Calibration
Performing...
9. Depends on calibration the result, a message appears on the LCD as shown below.In case of
succeeded sensor calibration
Calibration
Succeeded
10. In case of failed sensor calibration
Failed 12345
- - x - -
11. Press and hold [FEED] Key for three seconds to exit Menu Mode.
Firmware Version, CRC
Communication Interface
Printer Configuration
Printer Adjustment
Printer Test Modes
Sensor Calibration
Menu Mode Exit
Calibration with BM paper
Calibration with White Paper
Calibration with Label Paper
Calibration with Perforation Pap.
Return to Rrev. Layer
NOTE:
1. Press [MENU] key shortly,
it shifts the selection mode as
2. Press [PAUSE] key shortly,
it shifts the selection mode as
3. Press [FEED] key shortly,
Enter menu or save setting value
1: Paper End Sensor 2: Exit Sensor
3: TOF Sensor 4: BM Sensor
- : No Error X : Failure
E5-14
ENGLISH VERSION
5.7 Sensor Calibration
Main Menu
①
Function Menu
②
arrow.
arrow.
5: Label Sensor