Paper Set - Toshiba DB-EA4D SERIES Owner's Manual

5. PRINTER SETUP

5.1.2 Paper Set

NOTE:
Maximum paper width of 128mm is applied when Paper Roll Holder Option installed.
1. Load media on Paper Roll Holder Module,
First take out the Media Holder Unit from Hopper Unit.
2. Raise the Release Lever and remove
the Media Holder (Left) as shown below.
3. Insert the Media Shaft into the core of a media roll.
4. Assemble the Media Holder (Left) onto the Media
Shaft. Push the Media Holder (Left and Right)
against the media until it is held firmly in place.
This will automatically center the media.
5. Fold the Release Lever to lock the Media Holder (Left). Place the Media Holder Unit back to
Hopper Unit. The Paper Roll Holder Module is ready to be used.
6. Set roll paper to roll paper holder
as right picture.
7. Inset the paper correctly
until touching to platen.
Media Holder (Left)
E5-3
Insert
ENGLISH VERSION
5.1 Installation
Release Lever
Media Holder (Left)
Media
Shaft
Media Holder (Right)