Interface Setting; Parallel Interface Setting - Toshiba DB-EA4D SERIES Owner's Manual

5. PRINTER SETUP

5.5 INTERFACE SETTING

If use "Parallel interface" and "Ethernet interface", perform below sequence.
(Default Setting: USB)

5.5.1 PARALLEL INTERFACE SETTING

Sequence:
1. Select "Communication Interface" in main menu of Menu Mode.
And press [FEED] key shortly.
A message appears on the LCD, as shown below.
Interface Type
USB
2. Press [FEED] key shortly,
A message appears on the LCD, as shown below.
Interface Type
USB *
3. Select "Parallel",
And press [FEED] key shortly.
A message appears on the LCD, as shown below.
A setting is re-stored in the printer.
Parallel
Accepted
4. Press [FEED] key shortly.
A message appears on the LCD, as shown below
Interface Type
Parallel
5. Select "Return to Prev. Layer" in function menu
Of Communication Interface.
And press [FEED] key shortly.
6. Go to "5.6 Paper Type Setting"
Default Setting
NOTE:
1.
2.
3.
Firmware Version, CRC
Communication Interface
Printer Configuration
Printer Adjustment
Printer Test Modes
Sensor Calibration
Menu Mode Exit
Interface Type
Printer IP addr.
Subnet Mask
Default Gateway
Get IP Address
DHCP IP Address
Community (R)
Community (R/W)
IP Trap1
IP Trap1 Address
Trap1 Comm.Name
IP Trap2
IP Trap2 Address
Trap2 Comm.Name
MAC Addr.
Socket Port TCP
Socket Port UDP
Socket Port UDP2
Physical Layer
FTP User Name
Return to Prev. Layer
Press [MENU] key shortly,
it shifts the selection mode as
Press [PAUSE] key shortly,
it shifts the selection mode as
Press [FEED] key shortly,
Enter menu or save setting value
E5-8
ENGLISH VERSION
5.5 Interface Setting
Main Menu
①
Function Menu
②
arrow.
arrow.